top of page
Search

USBC Approves Ball Sensors, Updates Serial Number Rules and Exempts Balls 12 Pounds or Less from Gripping Hole Requirements

Nov 14
1 min read

The United States Bowling Congress has announced three equipment specification changes affecting bowling ball sensors, serial numbers and gripping holes.

The gripping hole exemption for bowling balls weighing 12 pounds or less is effective now. House balls also are exempt from gripping hole requirements.

Data acquisition devices approved

USBC approved the use of data acquisition devices in bowling balls following testing that found the lightweight sensors had no significant effect on ball motion or performance.

Under the updated specifications, each device must:

  • Weigh less than 0.5 ounces.

  • Be installed in an existing gripping hole or interchangeable gripping device.

  • Meet established ball balance requirements.

Only one sensor is permitted per ball.

Serial number restrictions begin January 1, 2028

Beginning January 1, 2028, bowling balls with re-engraved or unidentifiable serial numbers will not be permitted in USBC-certified competition.

Gripping hole exemption is in effect now

House balls and bowling balls weighing 12 pounds or less are exempt from gripping hole requirements. Bowlers do not have to wait until 2028 for this change—the 2028 effective date applies to the serial number restriction.

These changes are reflected in the updated USBC Equipment Specifications and Certifications Manual. For complete details, visit BOWL.com/Equipment-Specifications.

 
 
 

Comments


© 2025 Oregon State United States Bowling Congress. Powered and secured by Wix

bottom of page